Download or read book Guide to Verification and Validation of the SCALE-4 Criticality Safety Software written by and published by . This book was released on 1996 with total page 114 pages. Available in PDF, EPUB and Kindle. Book excerpt: Whenever a decision is made to newly install the SCALE nuclear criticality safety software on a computer system, the user should run a set of verification and validation (V & V) test cases to demonstrate that the software is properly installed and functioning correctly. This report is intended to serve as a guide for this V & V in that it specifies test cases to run and gives expected results. The report describes the V & V that has been performed for the nuclear criticality safety software in a version of SCALE-4. The verification problems specified by the code developers have been run, and the results compare favorably with those in the SCALE 4.2 baseline. The results reported in this document are from the SCALE 4.2P version which was run on an IBM RS/6000 workstation. These results verify that the SCALE-4 nuclear criticality safety software has been correctly installed and is functioning properly. A validation has been performed for KENO V.a utilizing the CSAS25 criticality sequence and the SCALE 27-group cross-section library for 233U, 235U, and 239Pu fissile, systems in a broad range of geometries and fissile fuel forms. The experimental models used for the validation were taken from three previous validations of KENO V.a. A statistical analysis of the calculated results was used to determine the average calculational bias and a subcritical k{sub eff} criteria for each class of systems validated. Included the statistical analysis is a means of estimating the margin of subcriticality in k{sub eff}. This validation demonstrates that KENO V.a and the 27-group library may be used for nuclear criticality safety computations provided the system being analyzed falls within the range of the experiments used in the validation.