Download or read book Development of a Simplified Asphalt Concrete Stiffness/fatigue Testing Device written by Nam H. Tran and published by . This book was released on 2004 with total page 354 pages. Available in PDF, EPUB and Kindle. Book excerpt: Mechanistic-empirical flexible pavement design procedures proposed for use within the 2002 Design Guide require the input of the dynamic modulus (E*) of hot-mix asphalt concrete. In addition, the E* test has been proposed as a "simple performance test" for use in mixture design and construction quality control. The objective of this study included conducting the dynamic modulus test, evaluating the accuracy/variability of test results, and constructing master curves for the mixtures tested. The hotmix asphalt mixes tested in this research are typically used for pavement construction in Arkansas, and binder content and air voids were varied to simulate typical construction variability. The analysis showed that the variability of the average dynamic modulus for each set of four replicates was acceptable. Since the dynamic modulus tests were run at intermediate temperatures in this study, a modified procedure, using Arrhenius and power functions, was employed to construct the master curves. Based on the master curves, the effects of aggregate size, binder content, and air voids on the tested asphalt mixtures were evaluated and determined to be consistent and reasonable. The testing procedure and results of this study were recommended for use in a new project to characterize the stiffness of Arkansas mixtures to prepare input data for the proposed 2002 Design Guide.