Download or read book RF Coil Design for Multi-frequency Magnetic Resonance Imaging and Spectroscopy written by Arash Dabirzadeh and published by . This book was released on 2010 with total page pages. Available in PDF, EPUB and Kindle. Book excerpt: Magnetic Resonance Spectroscopy is known as a valuable diagnostic tool for physicians as well as a research tool for biochemists. In addition to hydrogen (which is the most abundant atom with nuclear magnetic resonance capability), other species (such as 31P or 13C) are used as well, to obtain certain information such as metabolite concentrations in neural or muscular tissues. However, this requires nuclear magnetic resonance (NMR) transmitter/receivers (coils) capable of operating at multiple frequencies, while maintaining a good performance at each frequency. The objective of this work is to discuss various design approaches used for second-nuclei RF (radio frequency) coils, and to analyze the performance of a particular design, which includes using inductor-capacitor (LC) trap circuits on a 31P coil. The method can be easily applied to other nuclei. The main advantage of this trapping method is the enabling design of second-nuclei coils that are insertable into standard proton coils, maintaining a near-optimum performance for both nuclei. This capability is particularly applicable as MRI field strengths increase and the use of specialized proton coils becomes more prevalent. A thorough performance analysis shows the benefit of this method over other designs, which usually impose a significant signal-to-noise (SNR) sacrifice on one of the nuclei. A methodology based on a modular coil configuration was implemented, which allowed for optimization of LC trap decoupling as well as performance analysis. The 31P coil was used in conjunction with various standard 1H coil configurations (surface/volume/array), using the trap design to overcome the coupling problem (degraded SNR performance) mentioned above. An analytical model was developed and guidelines on trap design were provided to help optimize sensitivity. The performance was analyzed with respect to the untrapped case, using RF bench measurements as well as data obtained from the NMR scanner. Insertability of this coil design was then verified by using it with general-purpose proton coils available. Phantoms were built to mimic the phosphorus content normally found in biologic tissues in order to verify applicability of this coil for in vivo studies. The contribution of this work lies in the quantification of general design parameters to enable "insertable" second-nuclei coils, in terms of the effects on SNR and resonance frequency of a given proton coil.